Continuous Alignment – by always tracking the belt to the center of the conveyor, it reduces edge damage, spillage and overall better conveyor belt tracking performance.
Heavy-Duty – design of our clients uses 6205 6305 6306 6307 6308 6410 bearings, Q235 shaft, and an abrasive resistant hot-vulcanized rubber cover. Urethane covers are also available.
Patented Design – does not rely on the conveyor belt to activate an arm-type tracking mechanism. By utilizing an internal pivot versus external pivot it does NOT build up with carry back.
Reactionary – in both wet and dry conditions as seen in below ground and above ground mining all over the world.
Hnpal industry limited could solve your conveyor belt tracking problems and make your overall conveyor system run more efficiently.
Idler – can be used for belts traveling in one or reverse direction.
MOST RELIABLE AND RE-ACTIVE BELT TRACKING IDLERS!
Hnpal industry limited series of conveyor belt tracking idlers is a patented design that offers the most reliable and re-active belt tracking idlers available today.
Available in and Urethane
Belt Width 500mm-2500mm
Idlers can be mounted on the topside or clean side of the conveyor belt
Idler can be used for belts traveling in one or reverse direction.